ISO 17179:2016

Stationary source emissions — Determination of the mass concentration of ammonia in flue gas — Performance characteristics of automated measuring systems

ISO 17179:2016 specifies the fundamental structure and the most important performance characteristics of automated measuring systems for ammonia (NH₃) to be used on stationary source emissions, for example, combustion plants where SNCR/SCR NO_x control systems (deNO_x systems) are applied. The procedures to determine the performance characteristics are also specified. Furthermore, it describes methods and equipment to determine NH₃ in flue gases including the sampling system and sample gas conditioning system.

It describes extractive systems, based on direct and indirect measurement methods, and in situ systems, based on direct measurement methods, in connection with a range of analysers that operate using, for example, the following principles:

– ammonia conversion to, or reaction with NO, followed by chemiluminescence (CL) NO_x difference measurement for ammonia (differential NO_x);

– ammonia conversion to, or reaction with NO, followed by non-dispersive ultraviolet (NDUV) spectroscopy NO_x difference measurement for ammonia (differential NO_x);

– Fourier transform infrared (FTIR) spectroscopy;

– non-dispersive infrared (NDIR) spectroscopy with gas filter correlation (GFC);

– tuneable laser spectroscopy (TLS).

The method allows continuous monitoring with permanently installed measuring systems of NH₃ emissions, and is applicable to measurements of NH₃ in dry or wet flue gases, for process monitoring, long term monitoring of the performance of deNO_x systems and/or emission monitoring.

Other equivalent instrumental methods can be used, provided they meet the minimum requirements proposed in ISO 17179:2016. The measuring system can be calibrated with certified gases, in accordance with ISO 17179:2016, or comparable methods.

The differential NO_x technique using CL has been successfully tested on some power plants where the NO_x concentration and NH₃ concentration in flue gas after deNO_x systems are up to 50 mg (NO)/m³ and 10 mg (NH₃)/m³, respectively. AMS based on FTIR, NDIR with GFC and TLS has been used successfully in this application for measuring ranges as low as 10 mg (NH₃)/m³.

Edition	2016
Published Date	2016
Published By	International Standardization Organisation
Page Count	40